Seaview Sp2s1 Rail Pod – Uncut 11″ X 6.125″

Seaview Sp2s1 Rail Pod – Uncut 11″ X 6.125″

SP2S1 – Uncut Rail Pod

Max Useable Face: (11.75″ x 7″)

Max Cut Out Area: (11″ x 6.125″)

Seaview offers a solution to the age old problem of figuring out where to mount all your instruments on your sailboat. The Seaview Rail Pod allows you to mount smaller displays and instruments directly to the rail. Allowing you to postion the instrument where it is most optimal for you. Fits onto 1″, 1-1/8″ or 1-1/4″ rails. A single high polished 316 stainless steel clamp is used. Cables are routed internally through the clamp and into the rail. The Rail Pod housing is made from UV protected ABS plastic housing, and sealed with a water tight rubber gasket. Tamper resistant screws are used to hold the housing together. A reinforced base made from King Starboard is added for increased strength and stability (on certain models).

Stainless Steel Clamp

A single high polished stainless steel clamp is used to secure your Rail POD onto 1″, 1.125″ and 1.25″ (25mm to 32mm) rails. Seaview Rail Pods fit standard 9.5″, 12″ and non standard guard rails.

Security screws are used to hold the Rail Pod together. A water tight gasket is used to prevent water from entering inside the pod, while a GORE-TEX ventilation vent lets hot air to escape without letting water in.

Optional Accessory Pod

One of the unique abilities with this SPOD is the ability to add optional side pods. Currently no other sailboat pod on the market has this feature. Depending on the pod box size you choose you are able to mount either one to four of these accessory pods. This gives the customer lots of flexible solutions to optimize their setup. The SP1BOX is made of UV resistant white ABS plastic and held together with tamper resistant screws and sealed with a rubber gasket. 

Manufacturer Part Number: SP2S1